-
Posts
2142 -
Joined
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
StuartW's Achievements
Newbie (1/14)
84
Reputation
-
barneybrendan started following StuartW
-
little num started following StuartW
-
Ok thanks for that I need to find my old login details it sounds like. Cheers and glws on yours yours
-
Forgot but I still have this available
-
hi folks. I'm after a tt cylinder head. Condition not that vital as will use as a core for the drag car. Scorched a few this season and not viable to weld em up. Thanks Stu
-
most of the switch gear and 99% of faults lie in the stalk mechanism that can be bought for not a lot of money used, Try Keron. Hope that helps.
-
Xmas bump
-
open to offers mate...
-
Yes mate
-
Looking good mate, Yes there are rubber spacers that go under the 2x lower rad posts. I might be able to find some here if required mate.
-
Bump
-
You could use PHR solid engine mounts if its easier than cutting/modding..BUT always a rubber mount on the rear of the trans ;-)
-
Hi Mate, Great to have just read through this lot! Great work ;-) I would say around 10mm gap but ideally 15mm with the usage your gonna have!! Engine lies in line with the chassis rails. SUBSCRIBED :-)
-
Gonna keep bumpin this as when I was looking for a t6 manifold I scoured the earth!
-
Anybody know what grade/material the 2JZ cyl head is made from?
StuartW replied to StuartW's topic in mkiv Technical
Thanks for all the informative and technical replies. Still not any the wiser though :-( may e if someone could suggest a good race car welder/specialist?