alex341 Posted February 6, 2014 Share Posted February 6, 2014 What are peoples experiences with these? I'm looking to change my stock inlet, ideally I'd use a genuine greddy item but with the rest of my build getting out of hand my funds are dwindling. I've heard of sealing problems where they bolt to the inlet tubes (this would not be an issue as i could easily weld them.) Are there any other issues? Would I simply be better sticking with the stock Toyota inlet? Link to comment Share on other sites More sharing options...
ManwithSupra Posted February 6, 2014 Share Posted February 6, 2014 I think a few run them on here, They need a bit of machining to get right but nothing a Dremel cant fix. I am sure someone did a guide on here on it. Link to comment Share on other sites More sharing options...
baldy Posted February 6, 2014 Share Posted February 6, 2014 There are loads on eBay at the minute, I've got a raw cast one, yes it needed a bit of port matching but it's pretty good quality. A lot better than the chromed versions I've seen. I've also been told the greddy ones have been known to have sealing issues too Link to comment Share on other sites More sharing options...
James Posted February 6, 2014 Share Posted February 6, 2014 Speak to Lee P at SRD. He is now offering a plenum which is reminiscent of the GReddy intake Link to comment Share on other sites More sharing options...
Justin Bieber Posted February 6, 2014 Share Posted February 6, 2014 http://www.supraforums.com/forum/showthread.php?743073-Inside-the-knock-off-Greddy-intake-plenum Link to comment Share on other sites More sharing options...
alex341 Posted February 6, 2014 Author Share Posted February 6, 2014 I was looking at the cast finishes ones but these only seem to be available on American eBay Link to comment Share on other sites More sharing options...
Gpro Posted February 6, 2014 Share Posted February 6, 2014 What hp are you going for? Link to comment Share on other sites More sharing options...
alex341 Posted February 6, 2014 Author Share Posted February 6, 2014 650 maybe a tad more Link to comment Share on other sites More sharing options...
mwilkinson Posted February 6, 2014 Share Posted February 6, 2014 Look for my old build thread. I had a Godspeed one. Wasn't that bad to be honest. Link to comment Share on other sites More sharing options...
Gpro Posted February 6, 2014 Share Posted February 6, 2014 650 maybe a tad more Should be fine if not better then stock. Just don't go chasing 900+ with it, you probably can get the power but hypertune and other equivalents would flow a lot better which equals to better powerband Link to comment Share on other sites More sharing options...
Bossco Posted February 6, 2014 Share Posted February 6, 2014 I have a Greddy replica intake which I'll possibly be putting up for sale soon. It's with Rob Mitchell at the moment getting polished. Seems a very good bit of kit. Link to comment Share on other sites More sharing options...
alex341 Posted February 6, 2014 Author Share Posted February 6, 2014 Are the copy ones all the Same? The only ones I can find in the uk are like http://m.ebay.co.uk/itm/230860559829?nav=SEARCH&sbk=1 Where as the cast finish ones found on the u.s eBay seem to look better?? http://m.ebay.com/itm/370967264074?nav=SEARCH&sbk=1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now