wile e coyote Posted November 20, 2011 Share Posted November 20, 2011 Made a heat shield today and took some pics of the process. Used an old radio aerial to measure the hight to the bonnet when shut ,then cut out template from card board. i then cut some steel from template, not sure what to put on sharp edge yet thinking some door rubber Link to comment Share on other sites More sharing options...
Si_s Supe Posted November 20, 2011 Share Posted November 20, 2011 That looks great. I've got a Sonic Power too. I guess it helps having it double shielded. Link to comment Share on other sites More sharing options...
imi Posted November 21, 2011 Share Posted November 21, 2011 Looks really good Link to comment Share on other sites More sharing options...
Jimmy James Posted November 21, 2011 Share Posted November 21, 2011 Looks good Darren Link to comment Share on other sites More sharing options...
Westy Posted November 21, 2011 Share Posted November 21, 2011 Looks good...what about the hole at the back where the IC piping is...is that not letting alot of heat in!? Mind Jevansio making one of these ages ago and testing its efficiency with a temperature sensor built into the box! He got great results. Link to comment Share on other sites More sharing options...
Nic Posted November 21, 2011 Share Posted November 21, 2011 Do you still have the stock cool air feed that fits under the headlight? To be of any benefit it needs sealing completely so it's forced to draw in air from outside the engine bay. Link to comment Share on other sites More sharing options...
wile e coyote Posted November 21, 2011 Author Share Posted November 21, 2011 Nic i had removed that as put my hid boxes there but there is a large gap under light also. Back of the box i have orderd some car boot seal trim which ill also use along the top. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now