Shane Posted August 1, 2007 Share Posted August 1, 2007 Does anyone have a crank pulley handy? I need the distance in mm of the two threaded holes either side of the centre hole, centre to centre. Would be really helpful if someone could measure one for me. Thanks, Shane Quote Link to comment Share on other sites More sharing options...
Scooter Posted August 1, 2007 Share Posted August 1, 2007 not sure exactly what distance you are after but here some rough measurements......... 35mm centre whole diameter 15mm from the edge of this hole to centre of small holes 65mm between centre of each of the small holes. so 32.5mm from the centre point to each small holes centre........ i'll stop now as i'm not sure i'm being too clear!! Quote Link to comment Share on other sites More sharing options...
Konrad Posted August 1, 2007 Share Posted August 1, 2007 65mm between centre of each of the small holes. This is what he is looking for Quote Link to comment Share on other sites More sharing options...
Shane Posted August 1, 2007 Author Share Posted August 1, 2007 Thanks guys, much appreciated.:cool: Shane Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.