2JZMKIV Posted January 25, 2015 Share Posted January 25, 2015 My friends 95 6 speed supra rz (j-spec) has xxr wheels 19 inch pirelli p zero tyres 245/40r19 steering wheel feels like a truck recently did alignment checked the fluid its a lot heavier than mine possible cause ? Link to comment Share on other sites More sharing options...
Mike2JZ Posted January 26, 2015 Share Posted January 26, 2015 The repair manual states the following, check over each point and confirm that everything is as it should be: Link to comment Share on other sites More sharing options...
Abz Posted January 26, 2015 Share Posted January 26, 2015 Almost if the feel of the steering fluctuate whilst you are turning then it might be an idea to check the crank pulley. Link to comment Share on other sites More sharing options...
Chris Wilson Posted January 26, 2015 Share Posted January 26, 2015 Put some pressure on the steering wheel, turning to one side, with the engine off. Start engine, does steering immediately lighten? yes? PAS is working, whether optimally is subjective. No? PAS is knackered, investigate pressures and belt slippage. There's a solenoid valve in the rack that alters operating pressure under ECU control. Stationary and at low speeds the valve should be operating to increase PAS assistance. Above X MPH it slowly, by pulse width modulation, removes some amount of PAS assistance and the steering becomes heavier and less subject to light steering wheel inputs. This function may be faulty of there's PAS assist, but not enough when stationary or at low road speeds. I often see them not reconnected after an engine out, or the wiring and connector damaged. Link to comment Share on other sites More sharing options...
2JZMKIV Posted January 29, 2015 Author Share Posted January 29, 2015 thanks everyone its really helpful Link to comment Share on other sites More sharing options...
Guest RichardRobinson Posted January 30, 2015 Share Posted January 30, 2015 Almost if the feel of the steering fluctuate whilst you are turning then it might be an idea to check the crank pulley. Yeah, I think that is the problem. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now