When we meet op-amp design specifications, we can simplify our circuit calculations greatly, so much so that we don't need the op-amp's circuit model to determine the transfer function. Here is our inverting amplifier.

When we take advantage of the op-amp's characteristics large input impedance, large gain, and small output impedance we note the two following important facts.

- The current
*i*must be very small. The voltage produced by the dependent source is 10_{in}^{5}times the voltage*v*. Thus, the voltage v must be small, which means that in must be tiny. For example, if the output is about 1, the voltage*V*= 10*v*^{−}^{5}, making the current*V**i*_{in}= 10^{−}^{11}A. Consequently, we can ignore*i*_{in}in our calculations and assume it to be zero. - Because of this assumption essentially no current flow through
*R*_{in}the voltage v must also be essentially zero. This means that in op-amp circuits, the voltage across the op-amp's input is basically zero.

Armed with these approximations, let's return to our original circuit as shown in Figure 3.46. The node voltage e is essentially zero, meaning that it is essentially tied to the reference node. Thus, the current through the resistor ** R** equals . Furthermore, the feedback resistor
appears in parallel with the load resistor. Because the current going into the op-amp is zero, all of the current flowing through

**flows through the feedback resistor (**

*R*

*i***=**

*F***)! The voltage across the feedback resistor v equals . Because the left end of the feedback resistor is essentially attached to the reference node, the voltage across it equals the negative of that across the output resistor: . Using this approach makes analyzing new op-amp circuits much easier. When using this technique, check to make sure the results you obtain are consistent with the assumptions of essentially zero current entering the op-amp and nearly zero voltage across the op-amp's inputs.**

*i*
**Example 3.8**

Let's try this analysis technique on a simple extension of the inverting amplifier confguration shown in Figure 3.47 (Two Source Circuit). If either of the source-resistor combinations were not present, the inverting amplifier remains, and
we know that transfer function. By superposition, we know that the input-output relation is

When we start from scratch, the node joining the three resistors is at the same potential as the reference, , and the sum of currents flowing into that node is zero. Thus, the current ** i** flowing in the
resistor

**equals . Because the feedback resistor is essentially in parallel with the load resistor, the voltages must satisfy**

*RF**v = −*. In this way, we obtain the input-output relation given above.

**v**_{out}What utility does this circuit have? Can the basic notion of the circuit be extended without bound?

- 5156 reads