hadyn Posted July 26, 2006 Share Posted July 26, 2006 When applying a stick on number plate, do you do it dry or wet the surface and then apply the sticky plate? Any help in fitting one of these things without air bubbles would be greatly appreciated. Link to comment Share on other sites More sharing options...
JamieP Posted July 26, 2006 Share Posted July 26, 2006 little bit of fairy liquid in water mate... sponge it on then stick the plate on and work the water out;) Link to comment Share on other sites More sharing options...
Homer Posted July 26, 2006 Share Posted July 26, 2006 Where did you get your's from mate? Link to comment Share on other sites More sharing options...
JamieP Posted July 26, 2006 Share Posted July 26, 2006 Where did you get your's from mate? altype signs on the bath rd (next door to halfords) make them to any size and no ID is needed;) Link to comment Share on other sites More sharing options...
Ruff_Rider Posted July 26, 2006 Share Posted July 26, 2006 Are stick on plates road legal, assuming they are correct size and font etc? Does anyone know the size and font requirements? Link to comment Share on other sites More sharing options...
Mike Posted July 26, 2006 Share Posted July 26, 2006 Ed SupraStar has one... I'm sure he'll be along in a minute... Link to comment Share on other sites More sharing options...
blitz supra Posted July 26, 2006 Share Posted July 26, 2006 altype signs on the bath rd (next door to halfords) make them to any size and no ID is needed;) stick on plates... mmmmm But each to there own i suppose, ( before dummies get thrown out the pram) Nice small plates on the std bumper mounting look good ( i have motorbike size and never pulled by Mr Plod) Not going on the nose cone though i hope ???? that spoils the looks (saw a RX8 at JAE with a sticky on the nose cone and thought WTF!! are you doing!!! ) Try doing half and half thats how i do decals bit of masking tape each end to position it then put one peice of tape straight down middle vertically Peel off one side and remove backing and smooth out just that side then just peel off whats left of backing and smooth out that side again working from centre outwards Don't try and put it all on at once or from one end, Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now