linconhawk Posted April 17, 2012 Share Posted April 17, 2012 Had a search but not much detailed info came up.... Is there a correct / good way of attaching oem spats ? I have some fitted, but they are coming away... I was going to take them off and re-fit them. I am aware there are several screws, but how do you get them to fit flat against the bumper... Do you use tiger seal or something, if so, how would you hold / keep pressed into place untill set ? Any help would be appreciated.... Link to comment Share on other sites More sharing options...
jim Posted April 17, 2012 Share Posted April 17, 2012 I used some wood with rags wrapped around the ends, pushed up against the spats and then wedged against some wheels on the floor. Maybe better ways of doing it but they're still firm four years on. Link to comment Share on other sites More sharing options...
evinX Posted April 17, 2012 Share Posted April 17, 2012 Toyota used double sided tape. Yes, yes they did. Link to comment Share on other sites More sharing options...
Guigsy Posted April 17, 2012 Share Posted April 17, 2012 yep. its double sided tape stuff. like a thin piece of foam with glue on both sides. Link to comment Share on other sites More sharing options...
jay200bhp Posted April 17, 2012 Share Posted April 17, 2012 tiger seal then tape it up to the panel , Link to comment Share on other sites More sharing options...
Slam Posted April 17, 2012 Share Posted April 17, 2012 How about Pink or Grip-Fill Link to comment Share on other sites More sharing options...
Supra Gaz Posted April 17, 2012 Share Posted April 17, 2012 Please dont use tiger seal, i just removed my oem spats, tiger seal is the devil. Link to comment Share on other sites More sharing options...
Colin-mkiv Posted April 17, 2012 Share Posted April 17, 2012 Doublesided foam tape that you get from your local paint suppliers is the stuff to use. If all surfaces are cleaned properly before fitting then nothing will remove it, unless you vehemently need it off, then it comes apart at the foam section and you simply use glue softener to remove the sticky remains. Most cars body mouldings are secured in the very same way. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now