mikerunner Posted August 19, 2009 Share Posted August 19, 2009 need new clutch if anyone has one Link to comment Share on other sites More sharing options...
Paul Whiffin Posted August 19, 2009 Share Posted August 19, 2009 5 or 6 speed? Std or uprated? Link to comment Share on other sites More sharing options...
Chris Wilson Posted August 20, 2009 Share Posted August 20, 2009 I have one of my uprated stock clutches for the TT six speed built up ready to go. Price is £475. Info below Available now: Uprated MKIV six speed Getrag TT clutches. I use the stock, brand new driven plate, as it is correctly balanced, doesn't judder and will hold all but mega torque highly modded engines or cars used for drag racing. I modify a stock brand new OE cover to give more clamping force. The reason I tooled up to do these is some of the aftermarket US clutches I have fitted SEEM to be built from used cover assemblies with reground friction surfaces, and a stronger spring. I have had hellish trouble getting these to fully release, because due to this seemingly thinner cast iron friction face, the geometry of the clutch goes to pot, and being a pull type clutch (the hydraulics pull the bearing away from the engine, rather than the more normal push type) it is a lot harder to effect a cure. For 475 pounds, no VAT to pay, you get a brand new driven plate, a brand new modded cover, and a brand new release bearing. I would rather fit myself so any complaints are down to me, I see too many clutches juddering due to someone without the right gear fitting them, or clutches fitted to patently buggered flywheels. However, I might be persuaded to sell to people using bona fide fitters to install one. Toyota use a dual mass flywheel (the flywheel is in 2 parts, an inner and outer assembly, damped in the middle) which is now showing signs of wear causing a lot of rattle when idling or on very light throttle openings. For God knows what reason they are charging about 270 quid for a new one, they look more like they should be over 500 to me, but don't say anything :-) So if the flywheels old enough or abused enough to be scored it's best replaced. Fitting by myself will cost £175. Reply privately if interested please. [email protected] Link to comment Share on other sites More sharing options...
mikerunner Posted August 21, 2009 Author Share Posted August 21, 2009 6 speed twin turbo running full bbu std or uprated if good price Link to comment Share on other sites More sharing options...
Chris Wilson Posted August 21, 2009 Share Posted August 21, 2009 Mine is a good price..... Link to comment Share on other sites More sharing options...
mikerunner Posted August 23, 2009 Author Share Posted August 23, 2009 yes i agree good price would like you to fit but im in southampton quit a track to you Link to comment Share on other sites More sharing options...
Recommended Posts