ardasaliah Posted February 8, 2007 Share Posted February 8, 2007 Does the ECU pick up fault codes when the car does not fire up? E.g when the car is on ignition 2 just before the starter engages? The reason I ask is that the my car does not start- (no spark) Before I had a chance to check for codes the battery went flat from all the cranking i was doing so may have lost the codes stored. Once fully charged should the ECU pick up error codes even if the car does not fire up -- Hope this is clear. Link to comment Share on other sites More sharing options...
ardasaliah Posted February 9, 2007 Author Share Posted February 9, 2007 bump Link to comment Share on other sites More sharing options...
Ian C Posted February 9, 2007 Share Posted February 9, 2007 I'm not actually sure, I think it must do as for example the crank position sensor has a fault code and if it goes the engine won't start or run at all. -Ian Link to comment Share on other sites More sharing options...
ardasaliah Posted February 9, 2007 Author Share Posted February 9, 2007 So- I have no codes then. What could cause the car from not sparking? Other then a dodgy ignitor. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now