supramatt Posted March 2, 2004 Share Posted March 2, 2004 I have just installed a GReddy Profec B and have taken the pressure reading from a pipe on top of the inlet manifold. Is this right?? or is there somewhere else I should take that reading from? Cheers for helping a newb Link to comment Share on other sites More sharing options...
mawby Posted March 2, 2004 Share Posted March 2, 2004 Sounds correct to me. Link to comment Share on other sites More sharing options...
Guest Maverick Posted March 2, 2004 Share Posted March 2, 2004 Hi I was helping Matt with the install. We tee'd into the pipe that the boost pressure sensor is connected to. The same feed is then used for both the boost gauge and the Profec. The reason we were wondering if this is right, is because when tentatively increasing the duty cycle on the boost controller, the boost isn't increasing at all. I know that on my 200SX, I have low boost set at 53%, but wanted to know if everything is right before we try to turn it up further on the Supra. Cheers Hingy Link to comment Share on other sites More sharing options...
CJ Posted March 3, 2004 Share Posted March 3, 2004 [quick hijack] Maverick - I am from Abingdon too - are you a Supra owner? Link to comment Share on other sites More sharing options...
Guest Maverick Posted March 3, 2004 Share Posted March 3, 2004 Hi CJ Not a Supra owner, but a friend of a Supra owner. I've got a black 200SX. You should come to the Reading meets and say hi. Cheers Hingy Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now