Mkiv jdm
Followers-
Posts
23 -
Joined
Mkiv jdm's Achievements
Newbie (1/14)
0
Reputation
-
Chris I think your right best to just bite the bullet
-
I’m gonna try and take them out . Do the two nuts at each side of the sensor in the manifold need to come out or can you screw sensor out . With the heat I would say there probably welded on.
-
Only thing I can think is possible the reading is non existent . It says main fault is lower reading than 0.4 . My car isn’t Idling great + fuel consumption is lower than 15mpg. Car also smells very rich . Meter is coming up 0 . and with different pins it’s reading v
-
Thanks for your replies. I’ll keep a eye out
-
Posts 18 Feedback 0 I’ve tried Meter into both ox1 an ox2 with no readout what so ever . Cars getting very bad mpg . Talking 13 - 15 .. what does no read mean ? Tried in couple of the others and getting reads so nothing wrong with meter . Any ideas ��
-
I’ve tried Meter into both ox1 an ox2 with no readout what so ever . Cars getting very bad mpg . Talking 13 - 15 .. what does no read mean ? Tried in couple of the others and getting reads so nothing wrong with meter . Any ideas
-
Let me know how you get on Nathan .
-
Cheers will keep a eye out
-
Can you remap , chip or even putting a gte ecu into a standard ge with any gains
-
Where are you located ?? I’m looking a original the blitz front sticks out to much . Anyone wanna swap a blitz for a original ??
-
Ac93 I like the sound of that . Have you seen any kits for around that out put ? 700bhp would be nice but I’m still enjoying learning to drive rwd so 3 - 400 mark will be ample .
-
I also have a shed + tools . Done bits an pieces on my cars . Services etc . Wouldn’t be a total wizz . Can a small turbo be done diy or is it worth getting someone who does that sort of thing . Thanks again
-
Thanks very much all of you for your reply’s . No I would be happy to have 300-400bhp it’s a auto box aswell . NA is grand but a friend of mine has a UK spec TT and the extra kick it has really makes the difference. If I went for the likes of the T3 etc pull you have to swap out much stock on my GE? Also what exhaust would be free flowing and not deafening. I bought it with hks induction + a straight stanless s pipe blitz system but it’s way to loud for me , any advice on keeping it free flowing without being stupidly loud . ?
-
Well budget would be tight enough . What sort of money does a single fit roughly cost . I wouldn’t be looking to go too mad with power anywhere above 300 would be grand . That is some build your man has done in the link . Real proper job