Bomex SMIC ducting

Folks with Bomex bumpers and SMICs will be aware that the ducting isn't satisfactory.

As I've had a few days off work I've made up some ducting to give the SMIC a better chance to do it's job.

I've also added an aditional ATF cooler and PAS fluid cooler as insurance when doing track days.

I've got no photo's during fitting as my better half

p1ssed off to Nice for a few days and took the camera with her:rolleyes:

Now she's back I've grabbed some pic's.

The large duct is 125mm (5") the 3 smaller ones 63mm (2.5").

These are attached to a manifold plate made from 2mm ally fixed (and sealed with silicone sealant) to the mounting flange of the stock duct (previously cut from the duct).

Pic 1 is looking from above, pic 2 from below. The tape is just for sealing the intake duct to the bumper, not for structural integrity;)

The spot lights I took off are going on my daily driver as the candles on that are a bit dim:)