Rayman Posted October 23, 2006 Share Posted October 23, 2006 Im sure some of you have swapped your drivers side seat belt, how do you go about doing it, im presuming the plastic has to come out, near the rear speaker grill etc. How do i go about starting to remove it? The only screw i can see is when i look directly at the seatbelt from outside the car, the screw in question has a cap over it that you can remove. Ive found this screw but it wont undo, it just keeps spinning round, tried it on the pass side too and the same faulty screw thread. See below for screw im on about. Is the trim just pulled out after that screw is removed? Thanks http://img334.imageshack.us/img334/1286/p1010083ur3.jpg Link to comment Share on other sites More sharing options...
MONKEYmark Posted October 24, 2006 Share Posted October 24, 2006 the round plugs you can pop off with a screwdrver with flat blade.there is a screw underneath to remove plastic trim.then you can see where the seat belts fasten to bodywork. easy job Link to comment Share on other sites More sharing options...
Rayman Posted October 24, 2006 Author Share Posted October 24, 2006 the round plugs you can pop off with a screwdrver with flat blade.there is a screw underneath to remove plastic trim.then you can see where the seat belts fasten to bodywork. easy job That screw you take off, my screw just spins rounds, will it need to be drilled off now!? Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now