Billy Posted May 23, 2006 Share Posted May 23, 2006 I want to fit a water temp gauge so I can see what the water temp is going to in degrees rather than just looking at the simple temp gauge on the dash does anyone know were the easiest place to fit the temp sensor would be Link to comment Share on other sites More sharing options...
Prof. Monkey Posted May 23, 2006 Share Posted May 23, 2006 You can get kits that you basically cut the top radiator hose, fit an alloy sleeve (many colours) and the temp sender goes in there. I would fit the 52mm gauge, if that is what it is, in place of the clock, and you can use the loom there for power. The hole for the clock is 52mm! Hope this helps... Look at demon-tweeks? Link to comment Share on other sites More sharing options...
Billy Posted May 23, 2006 Author Share Posted May 23, 2006 thanks for that Link to comment Share on other sites More sharing options...
Soonto_HAS_soop Posted May 23, 2006 Share Posted May 23, 2006 I installed mine in the elbow with the turbo coolant take offs, above the water pump, it does the job just nicely there. I drilled and tapped a hole for a screw thread sensor, has wokred fine since I installed it. Link to comment Share on other sites More sharing options...
Billy Posted May 23, 2006 Author Share Posted May 23, 2006 i see on demon tweaks they do a kit that fits into the top rad hose does any body know what the dia of th top rad hose is Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now