jackso11 Posted April 16, 2006 Share Posted April 16, 2006 Right here is a challenge for you all.... The last owner of my car changed the rear Toyota oval badge for a gold bling badge. I have removed this to put an original back on and discovered that whoever took the original badge off dicided to cut it off leaving the 3 locating plugs in the hole! So how can I get the little stubs out of the locating holes, as they are cut level with the paint of the car..... Link to comment Share on other sites More sharing options...
Kev.O Posted April 16, 2006 Share Posted April 16, 2006 How about drilling through the existing plugs, really carefully? How big is the plastic left in there? Link to comment Share on other sites More sharing options...
whitesupratt Posted April 16, 2006 Share Posted April 16, 2006 Just get something thin and pointed, like a thing screw driver or drill bit or allen key and punch 'em through! Link to comment Share on other sites More sharing options...
Soonto_HAS_soop Posted April 17, 2006 Share Posted April 17, 2006 Just get something thin and pointed, like a thing screw driver or drill bit or allen key and punch 'em through! Link to comment Share on other sites More sharing options...
Ulrik Posted April 17, 2006 Share Posted April 17, 2006 I had simular problem , when i removed mine. There was a little part so i could "take them out". Mabye they would rattle or make some sounds if they are inside of the hatch ? Best is to try and get them out i guess.... If you dont want to remove the plastic trim on the inside.. Link to comment Share on other sites More sharing options...
edd_t Posted April 17, 2006 Share Posted April 17, 2006 are they plastic? heat up a needle, and burn them out edit: melt them out even! lol Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now