bigbloodyturbo Posted May 7, 2011 Share Posted May 7, 2011 I'm in the process of taking the turbo's of the side of my TT and to get the egv valve out i'm going to drop my whole exhaust out of the way. However the cat temp sensor appears to be seized in place and both bolts have corroded so bad there are no flats left on them. Is it ok to just cut the sensor of from its loom as i know tieing it to one side is ok? has anyone done this? Link to comment Share on other sites More sharing options...
bigbloodyturbo Posted May 7, 2011 Author Share Posted May 7, 2011 Too late Link to comment Share on other sites More sharing options...
scotty71 Posted May 7, 2011 Share Posted May 7, 2011 should be ok, insulate the end though Link to comment Share on other sites More sharing options...
bigbloodyturbo Posted May 7, 2011 Author Share Posted May 7, 2011 should be ok, insulate the end though I just cut it off, i might splice it back on if it causes an error light to come on but if not then i suppose its electrical tape time! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now