icio471

the only thing that i can think is that.... i have changed the radiator and i don't know... probably there is too much water insted coolant?? mmm..

thermostat is ok. is not stuck.

Hi guys i have a Supra recently swapped from 2jz ge to 2jz-gte. Before the swap i remember fine that during winter heater worked perfectly. Today i checked with the mechanic which could be the problem and looking from the engine all works correctly. someone could give me an idea? i have noted also that with hot engine if i turn in max temperature , you can feel a few warm air but really few. SUggestions? thank you in advance:D

Tomorrow a friend of that place try to hear someone and i hope to find more informations. Meanwhile i'm hoping to find an help here.... if this car is completed abandoned without an owner.... will be impossible buy it.

Guys the picture has the plate covered because i take it from a guy that has covered it. Than i discover where is it and i found it. But believe me the reg plate is LI00 SWS. How can i find the owner??

Hi dears , I want to buy a supra that i found in italy but it has an uk reg plate. Who can help me to find the owner?? Number is LI00 SWS

Hello guys, today i decided to do an uprated on my supra . Dash pannels was very bad so decided to repaint it from white to black. speedometer has the old yellow lights so decided to go in a shop and buy new whitte led lights. put the new lights but suprise... when lights are on odomoter is off... ok no problem i thought in a first moment. Try again with the original like in origin and fuck... it's the same... so now i have the original speedodometer with original lights that is off but if i turn the key in second position work only master stop,handbrake stop and if i try the arrows... so... what fuck is happend?? i'm very angry now ,this car has a lot problems with wirings , isn't the first time that i have one, infact after this , i discovered a new surprise connecting the odo... turn the lights bottom and disappear the total amount of the km... i don't know how i have to do. any advice for me?some similiar experience? i have also the small box 3 cmx2cm that you use to convert kph to mph and i think that this could be a problem now... do you think that is a solution start to remake the original configuration and take off this small box?.... Please help me is impossible i removed the speedometer in 2 years 4 5 times... and this is the first time that happend this. I want to say you that speedometer work correctly but is a problem only for the lights........

hi guys, problem isn't solved. after the union of the pink wire with blu/red, i didn't remove the battery ... i have to do it?because the problem continue to remain again... i think that maybe when the car arrived in uk the old owner converted the odo in mph but when the car was bought from the last italian owner before me , he probably tried to convert again in km, and this is the result... someone could give me the original configuration of the wirings?? because now i have probably a mix of the job conversion. i've seen that there is also a micro box connected that probably was used to convert in miles the odo..... if someone understand like to resolve it , tomorrow i could attach a picture to show you like is the configuration now. Thanks for all

ok guys yes my car is a japan model not uk model so i tried to follow the instructions to fix error code 42.... now i will update you. how can i reset the ecu now?

What i have to do? it's serious problem or what is it?

probably i' ve found the error in another site. should be DCT. no 42 speed sensor signal circuit for M/T) i think Manual transmission and it's like mine. then is written: " all conditions are detected continuosly for 8 sec or more, infact continue to repet it 4 flash small pause 2, long pause 4 flash small pause 2 etc..., then, a)no.1 speed signal 0 mph/kmh b) engine speed between 1500 to 4000 rpm rpm or more c) coolant temp 80 grades or more d) load driving WHAT MEANS??

ok guys amazing... flash 4 times pause 2... what error code is it?

So.... you are telling me that i can use an any metal wire put between E1 and TE1 and turning the key in second position the yellow engine should be do some falsh?? if i understood fine... it's amazing! i try to find a metal wire... i have an idea .

i understood but the problem is that i haven't any wire... so my question is , if i buy that adaptors and i use a tool for lexus with 2jz ge , is it possible or not?

but i have to buy that adaptors or not? i have no flash when i turn the key...