jason m Posted May 16, 2006 Share Posted May 16, 2006 I have the black plastic thing on the back of the car at the mo. but am probably going to remove it, to fit a new number plate. Does anyone have the dimensions needed for the rear plate to cover the holes which I understand are under this plastic thing? Thanks Quote Link to comment Share on other sites More sharing options...
edd_t Posted May 16, 2006 Share Posted May 16, 2006 when i took my stupid plastic things off, the plate was large enough to fit over the 1 very large whole in the middle. if your plate fills all the gap between the stupid plastic things, you should be ok. Quote Link to comment Share on other sites More sharing options...
jason m Posted May 16, 2006 Author Share Posted May 16, 2006 Ok will have a look, how does it come off as a matter of interest? (before I break it accidentally) Quote Link to comment Share on other sites More sharing options...
edd_t Posted May 16, 2006 Share Posted May 16, 2006 ok theres 2 screws, either side of the number plate light thing. you will need to take the current plate off, then undo the screws. then gently pull the plastic things away from the body, as they will be stuck on with double sided tape stuff. only takes 20 mins! then about an hour to polish out the marks it leaves! dont forget to put the screws back in, as they hold the light in place. Quote Link to comment Share on other sites More sharing options...
jason m Posted May 16, 2006 Author Share Posted May 16, 2006 Quote Link to comment Share on other sites More sharing options...
edd_t Posted May 16, 2006 Share Posted May 16, 2006 No problemo! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.