Guest DEREHAM SUPRA Posted February 17, 2007 Share Posted February 17, 2007 had the dreaded starter motor solenoid click-starter not turning problem, bought the parts from my local MrT. This afternoon started to take the starter motor out, removed the electrical connections and the two holding bolts, major problem, can`t get it past eveything to get it to the deck, pipes or cross-members in the way, any ideas greatly appreciated. Thanks Mark Quote Link to comment Share on other sites More sharing options...
absz Posted February 17, 2007 Share Posted February 17, 2007 the only thing that i removed out of the way was the earth strap which goes to the fuel filter, apart from that it just fall to the floor:d Quote Link to comment Share on other sites More sharing options...
absz Posted February 17, 2007 Share Posted February 17, 2007 just a thought, it come out from the back of the cross-member near the fuel filter. Quote Link to comment Share on other sites More sharing options...
Guest DEREHAM SUPRA Posted February 17, 2007 Share Posted February 17, 2007 tried this way several times but because mines a manual the clutch linkage is in the way. Quote Link to comment Share on other sites More sharing options...
absz Posted February 17, 2007 Share Posted February 17, 2007 tried this way several times but because mines a manual the clutch linkage is in the way. ahh i see:innocent: Quote Link to comment Share on other sites More sharing options...
TrickTT Posted February 18, 2007 Share Posted February 18, 2007 Just change the contacts from under the car. Its easier to do just by moving the starter motor into a position where you can get at the back of the solenoid, then rest it on the subframe, than to start removing clutch parts to get it out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.