Jump to content
The mkiv Supra Owners Club

Anyone running a Supralink Link plug in?


Swampy442
 Share

Recommended Posts

Out the box the link will work with the two stock knock sensors. I find that if the engine is still stock, with twins then the noise from stock sensors is fairly accurate and ok to use. Once you start doing single turbos, big cams and built engines then I normally use two bosch wideband knock sensors.

 

Bosch sensors are two wire. One wire needs to go to the Knock1 & Knock 2 pins on the Link, then the other wire you will need to connect to sensor ground pin. If you are using shielded wire (recomended), then you will have a third wire for the shield that you can ground to the chassis in the footwell.

Link to comment
Share on other sites

Exactly what I was after, cheers. What about the MAP sensor?

 

It will use stock map sensor out the box. But you will be limited to 1.3 bar ish of pressure before sensor konks out.

 

If you get a Link 3 bar or higher sensor, then you can cut the stock map sensor plug off and wire in 3 wire direct to link map sensor. You need 5v, sensor gnd and signal.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. You might also be interested in our Guidelines, Privacy Policy and Terms of Use.