Results 1 to 7 of 7

Thread: how to remove door weather strip

  1. #1
    learned the hard way Club Member renegade's Avatar
    Join Date
    Dec 2006
    Location
    Scotland - Grampian
    Posts
    249
    Feedback
    0

    how to remove door weather strip

    what all has to be done to remove the door weather strip. does it just pull off? is there any screws
    Last edited by renegade; 09-01-19 at 13:45.
    Never Underestimate the intelligent of Stupidity

  2. #2
    Work... what work? Club Member P_Bazz's Avatar
    Join Date
    Dec 2012
    Location
    Netherlands
    Posts
    197
    Feedback
    3 (100%)
    Lower the windows and pull off the door cards, there are two screws that hold them to the door. Be sure to use the right size screwdriver as they will easily strip and you cannot replace them with normal bolts as they will hit/scratch the glass when going up and down. Another method is to make a notch with a small chisel and carefully hammer them in a anti-clockwise fashion if they do happen to strip. (Part no. 90154-60027)

    Last edited by P_Bazz; 09-01-19 at 13:56.

  3. #3
    learned the hard way Club Member renegade's Avatar
    Join Date
    Dec 2006
    Location
    Scotland - Grampian
    Posts
    249
    Feedback
    0
    I have the new parts75720 and 75710. so take door cards off then?
    Never Underestimate the intelligent of Stupidity

  4. #4
    Work... what work? Club Member P_Bazz's Avatar
    Join Date
    Dec 2012
    Location
    Netherlands
    Posts
    197
    Feedback
    3 (100%)
    Quote Originally Posted by renegade View Post
    I have the new parts75720 and 75710. so take door cards off then?
    Exactly. The part no. I mentioned was for the screws. Don't try and push the weatherstrips down to hard either, they always stick up a little bit. Just match them with the trim part on the rear quarter windows in height.

  5. #5
    Silent lurker... Club Member Rob W's Avatar
    Join Date
    Nov 2003
    Location
    England - Kent
    Posts
    1,388
    Feedback
    19 (100%)
    Yes remove the door card. 2 screws holding them on, 1 at each end IIRC.
    95 J-Spec TT BPU+

  6. #6
    learned the hard way Club Member renegade's Avatar
    Join Date
    Dec 2006
    Location
    Scotland - Grampian
    Posts
    249
    Feedback
    0
    got the drivers side done. other side not so good screws not moving put lots of wd40 on not sure if they will come out whole.
    Never Underestimate the intelligent of Stupidity

  7. #7
    Work... what work? Club Member
    Join Date
    Aug 2017
    Location
    South Africa
    Posts
    315
    Feedback
    0
    Can you post a photo of the screw pls? Someone?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •