Jump to content
The mkiv Supra Owners Club

RZtwin

Club Members
  • Posts

    164
  • Joined

RZtwin's Achievements

Newbie

Newbie (1/14)

  • Reacting Well Rare
  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done

Recent Badges

0

Reputation

  1. Anyone have pictures/info of how to delete the ABS on a TT RZ Supra?
  2. Hello, I'm looking to delete my TRAC pump. I thought this was the ABS actuator? Can someone tell me where to locate my TRAC pump? 1993 JDM Supra RZ Thank you
  3. Will these K sport brakes clear BBS LM wheels? 18x10 50offset ?
  4. May I ask what this sold for please?
  5. Good Knowledge!! But I am Haltech ecu and no cats. Can I remove wire completely and have no dash light?
  6. Could I delete this sensor and wire all together without any negative effects?
  7. Using Haltech 2500 Elite on my 2jzgte. Has anyone installed these 2 pin Bosch knock sensors to replace the JDM single wire ones? If yes can you tell/show me how you did? Thanks:)
  8. Thank you Mike! Can I use the existing old factory signal wires to the new Bosch knock sensors and use a NEW shielded wire from knocks too Haltech ecu? Does my diagram look correct?
  9. Hello Alex, I need info to install my 2 0261231188 BOSCH knock sensors. Is this the proper way to wire new Bosch knock sensors? As you alteady know, the jdm supra 2jzgte currently has 1 wire going to each oem knock sensor. 1. Does polarity matter with these 2 pin knock sensors??? 2. Do I NEED to ground shielding mesh. 3. I am using Haltech elite 2500 ecu. Using the Haltech Plug and Play harness which has the AUX connector for me to connect sensors too. 4. Is my drawing correct? 5. Can I use the factory signal wires to my new knock sensors and use new shielded wires for the grounds?
  10. Help me install my 2 Bosch knock sensors please
  11. Hello, I would very much appreciate any info on this topic as I have not finished this portion of my build yet. Thank you RajR34.
  12. Is this the proper way to wire new Bosch knock sensors? My jdm supra 2jzgte currently has 1 wire going to each oem knock sensor. Using Haltech elite 2500. 1. Does polarity matter??? 2. Do I NEED to ground shielding mesh to body ??
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. You might also be interested in our Guidelines, Privacy Policy and Terms of Use.