Jump to content
The mkiv Supra Owners Club

7677243

Followers
  • Posts

    55
  • Joined

7677243's Achievements

Apprentice

Apprentice (3/14)

  • Dedicated
  • First Post
  • Collaborator
  • Conversation Starter
  • Reacting Well Rare

Recent Badges

8

Reputation

  1. I previously had an issue similar to what you describe, mine would slip and free rev or fully engage, there didn't seem to be a progression in-between. It was a very short time between that first event and full failure for me. My fluid levels were correct but I was abusing it fairly heavily over a couple of years. I changed the clutch pack in the gearbox to resolve.
  2. Seem that one, it has the buttons offset and the ones on my remote are both on the outer edge. Thanks anyway, I appreciate the time.
  3. That's the whole system, patches into 3 parts of factory wiring and one wire quick spliced. Anyone know where to get that key case?
  4. You're right, there is a jumper loom and no button on the side of the box with this module. From memory it is as simple as unplug a connector from your existing wiring, plug the loom which comes with this box into each side of the now unplugged connector and then splice in the last wire or two with those cheater splicer bits (blue in your pic). I have the whole loom out the car but need to pop to my garage and should also have pictures of it installed. The jumper loom sits in the drivers side footwell fusebox area and the box under the drivers seat.
  5. I also had this in my japanese supra, still have the box and one key fob chip but the key is in bad shape and I couldn't find a new case for the chip. It was quite easy to remove because of the way it is spliced in, I will have some pictures of it all somewhere when I removed it. Give me a few days, I will see what I can find.
  6. Do the seat rails from manual seats swap over to the electric seats? I am done fiddling with the electric mechanisms and cogs for forward/backwards motion Cheers.
  7. Do you still have good clearance from the top of the intake to the bonnet? Looking forward to pics.
  8. You can hook up a light to the injector to make sure its firing while cranking. Keep in mind after the ECU receives no confirmation of ignition fired (IGF signal) after 2s it cuts fuel to avoid flooding the cylinder, so your light will stop blinking if your issue is spark or ignitor related.
  9. Just filled an empty system and was approx 900ml with UK brakes and reservoir full afterwards, posting for anyone searching in the future as you already have a bob on answer
  10. Nice job Krimi, I've just done a similar scale build and can appreciate the attention to detail. Great job! Enjoy that, a fun decade of trouble free hooning ahead Curious on what you did to restore the door cards. They look great. Did you remove the full skin and start from there?
  11. Found. Thanks evinX
  12. To help with the spring compress it in a vice and loop some fishing line around it, when it's assembled cut the line.
  13. My reply from MVP for anyone also sourcing a condenser: In stock, no, backordered 90 days. But not discontinued, or at least it wasn't last month as I ordered 2 of them and Denso confirmed my order. Since the lines that mount to the back of the condenser to the drier are also NLA from Toyota I will try to order the lot from Keron.
  14. I am pretty confident that no TT FFIM fits on NA heads auto or otherwise. Keep the comb over manifold, looks cool on NA-T imo
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. You might also be interested in our Guidelines, Privacy Policy and Terms of Use.