-
Posts
164 -
Joined
RZtwin's Achievements
-
RZtwin started following JDM Supra 2jzgte turbo swap , How to remove JSpec ABS ? , Jspec JDM TRAC pump location? and 7 others
-
Anyone have pictures/info of how to delete the ABS on a TT RZ Supra?
-
Hello, I'm looking to delete my TRAC pump. I thought this was the ABS actuator? Can someone tell me where to locate my TRAC pump? 1993 JDM Supra RZ Thank you
-
Now Sold - Used K-Sport 8 pot 356mm Front Brakes
RZtwin replied to Peter P's topic in Parts for Sale
Will these K sport brakes clear BBS LM wheels? 18x10 50offset ? -
Used OEM Toyota Supra 93-98 Side Markers indicators
RZtwin replied to RZtwin's topic in Parts for Sale
25usd plus shipping -
May I ask what this sold for please?
-
Good Knowledge!! But I am Haltech ecu and no cats. Can I remove wire completely and have no dash light?
-
Could I delete this sensor and wire all together without any negative effects?
-
Using Haltech 2500 Elite on my 2jzgte. Has anyone installed these 2 pin Bosch knock sensors to replace the JDM single wire ones? If yes can you tell/show me how you did? Thanks:)
-
Thank you Mike! Can I use the existing old factory signal wires to the new Bosch knock sensors and use a NEW shielded wire from knocks too Haltech ecu? Does my diagram look correct?
-
Hello Alex, I need info to install my 2 0261231188 BOSCH knock sensors. Is this the proper way to wire new Bosch knock sensors? As you alteady know, the jdm supra 2jzgte currently has 1 wire going to each oem knock sensor. 1. Does polarity matter with these 2 pin knock sensors??? 2. Do I NEED to ground shielding mesh. 3. I am using Haltech elite 2500 ecu. Using the Haltech Plug and Play harness which has the AUX connector for me to connect sensors too. 4. Is my drawing correct? 5. Can I use the factory signal wires to my new knock sensors and use new shielded wires for the grounds?
-
Help me install my 2 Bosch knock sensors please
-
Hello, I would very much appreciate any info on this topic as I have not finished this portion of my build yet. Thank you RajR34.
-
Haltech elite 2500 ecu
-
Anyone?
-
Is this the proper way to wire new Bosch knock sensors? My jdm supra 2jzgte currently has 1 wire going to each oem knock sensor. Using Haltech elite 2500. 1. Does polarity matter??? 2. Do I NEED to ground shielding mesh to body ??