Guest blownbytwins Posted December 28, 2006 Share Posted December 28, 2006 -------------------------------------------------------------------------------- hi guys,ive recently changed the coolent on the supe i used the toyota stuff but it doesnt seem to get very warm inside it woz fine b4 i changed it,its not overheatin and its drivin fine,any ideas wot it could be,should i rebleed it again?wots the best way to bleed the supe? Quote Link to comment Share on other sites More sharing options...
NUTKIN Posted December 28, 2006 Share Posted December 28, 2006 Yes please someone answer this question cause i got same prob everytime i put my foot down u can hear water movin in the matrix cause of airlocks an cant get it out Quote Link to comment Share on other sites More sharing options...
merckx Posted December 28, 2006 Share Posted December 28, 2006 When the engine is cold. Pull off the top heater hose which is at the rear of the engine and fill with coolant, do this slowly to avoid trapping air. Fill the resevoir to the full line. You should always have your heater on max temp to allow coolant to flow into the heater when whilst renewing the coolant. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.