Bob Posted August 25, 2006 Share Posted August 25, 2006 Does anyone know where I can get some of the screw-in outlets for the Greddy Profec boost valve? They're 6mm diameter outlets, used on the E01 and B spec 2 boost controller solenoids. I think the thread is about 10mm but may be an imperial / American size. Quote Link to comment Share on other sites More sharing options...
LeeT Posted August 25, 2006 Share Posted August 25, 2006 i bet its a 1/8" npt thread. is it a very fine thread? If you can take a pic of what you need im sure someone will be able to help. I have something similar here but not sure on the push fit size Quote Link to comment Share on other sites More sharing options...
Bob Posted August 25, 2006 Author Share Posted August 25, 2006 It measures at *roughly* 9mm. I took some crappy phone pics of the hole, and an exert from the manual. It seems that they're not a part that Greddy supply on their own; I've been in contact with Mohd Parts in the US and they suggest going to a hardware store - damned if I've ever seen anything like these in a UK hardware store though! Quote Link to comment Share on other sites More sharing options...
LeeT Posted August 25, 2006 Share Posted August 25, 2006 They look like 1/8" npt thread nipples. You can buy them from shops that sell and make up hydraulic/pneumatic lines etc. I bought one a while back for about £1. 1/8" bsp will also fit so may well worth trying a plumbing store. The ones i may have here will fit i think. I'll have a look tomorrow for you to see if i can find two. If i can i will send them free of charge for you. Quote Link to comment Share on other sites More sharing options...
Bob Posted August 25, 2006 Author Share Posted August 25, 2006 Cheers Lee, you're a gent! Quote Link to comment Share on other sites More sharing options...
LeeT Posted August 25, 2006 Share Posted August 25, 2006 Cheers Lee, you're a gent! BOB, PM me your address. I have just found a couple that should do for you Quote Link to comment Share on other sites More sharing options...
Bob Posted September 28, 2006 Author Share Posted September 28, 2006 Just in case anyone needs these in the future, they are a 1/8 BSPT / BSPP thread Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.