Twin Feed Stock Rail

[smarty]

How easy is it to make a stock rail dual feed?

What is needed to do this?

Can anyone do this?

Thanks

[Wez]

It has been done many times before, a search should kick up some stuff for you.

Not sure how much of a requirement it is though.

[LeeT]

How easy is it to make a stock rail dual feed?

What is needed to do this?

Can anyone do this?

Thanks

i done mine with no problems. you just need the right size drills and taps to suit the -6an fitting you are going to be using. I tapped mine out the same thread as the other end which was m12x1.25 then used a M12x1.25/-6an adapter

[Wez]

http://www.mkivsupra.net/vbb/showthread.php?t=63652&highlight=dual+feed

[JamieP]

Mine has been done by turbofit.:)

[smarty]

Anyone got any pics of a modified fuel rail?

I am only thinking of doing this as i will be going single soon. I am running PE650cc injectors, just want to make sure that there is plenty of fuel around all the injectors, especially around number 1.

[JamieP]

best i can do;)

http://i30.photobucket.com/albums/c338/jamie450x/stockfuelrail.jpg

[smarty]

Cheers for that Jamie.

I presume you are running dual pumps with your car?

Think i would only need to put a 'Y Piece' from my feed line to both ends of the rail.

[JamieP]

yes im on twin pumps.

[smarty]

Jamie do you know how much Turbofit charged you to do this?

I have a -6 line coming to remove the fuel dampener so would need a Y piece from that then bits of pipe from the y to both ends of the rail.

[BURT]

here you go.. cost about £35 with the fittings

[smarty]

here you go.. cost about £35 with the fittings

Would you be willing to drill mine for me mate and supply the fittings?

Obviously for a fee :)

Would rather someone who has done this before do it rather than me mess it up :D

[BURT]

where abouts are you matey??

[smarty]

Northants mate, but can send you the rail in the post, its in bits at the minute anyway :)

[JamieP]

Jamie do you know how much Turbofit charged you to do this?

I have a -6 line coming to remove the fuel dampener so would need a Y piece from that then bits of pipe from the y to both ends of the rail.

I cant remember but it aint much.. best to phone greg.

[BURT]

Northants mate, but can send you the rail in the post, its in bits at the minute anyway :)

send it to pheonix bud... give mark a call on 01923228484. he is not far from you bud,

[smarty]

Thanks guys, will have a ring round. :thumbs: