Missile Posted July 21, 2006 Share Posted July 21, 2006 Driving to work this morning, Went to change gear to find the clutch was stuck the the floor, Any ideas to why this may be, I have to lift it myself each time to take it out of gear, Well annoying, Is there an automatic adjuster mechanisum that could have broken etc, Or is it likely to be a servo prob. Chris:tongue: Quote Link to comment Share on other sites More sharing options...
Missile Posted July 21, 2006 Author Share Posted July 21, 2006 Quote Link to comment Share on other sites More sharing options...
Ruff_Rider Posted July 21, 2006 Share Posted July 21, 2006 Not sure why this would be but do you mean lift it to put into gear? Quote Link to comment Share on other sites More sharing options...
ross Posted July 21, 2006 Share Posted July 21, 2006 not entirely sure but it could be either the master or the slave cylinder. Had the same problem on mine a while ago. after a while it wouldn't even change gear. Do you find that sometimes the clutch works and other times it doesn't? this might get worse as time goes on like mine did. not too big a problem to sort if it is. The master is located on the bulkhead adjacent to the stearing wheel. The slave is underneath the car next to your gearbox. (or might be the other way round). Not too hard to replace if you know what your doing. Just awkward. Hope this helps mate Quote Link to comment Share on other sites More sharing options...
tbourner Posted July 21, 2006 Share Posted July 21, 2006 Isn't it just a spring on the pedal that pulls it back up? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.