dangerous rep Posted March 14, 2006 Share Posted March 14, 2006 what is this front splitter and where could i get one?? what price etc. thanks Quote Link to comment Share on other sites More sharing options...
edd_t Posted March 14, 2006 Share Posted March 14, 2006 hey i like that, havnt seen that one before. would also be intrested to know... Quote Link to comment Share on other sites More sharing options...
Ian W Posted March 14, 2006 Share Posted March 14, 2006 looks a bit like the one Paul Whiffin does....although it's very slightly different i think. am looking at the Greddy one myself. Quote Link to comment Share on other sites More sharing options...
mr lover Posted March 14, 2006 Share Posted March 14, 2006 that is mr t new car pm him http://www.mkivsupra.net/vbb/member.php?u=1436 Quote Link to comment Share on other sites More sharing options...
Ian W Posted March 14, 2006 Share Posted March 14, 2006 i take it back, i'm fairly sure it's a Whifbitz front lip after seeing another couple of pics. Quote Link to comment Share on other sites More sharing options...
SupraJames Posted March 14, 2006 Share Posted March 14, 2006 looks a bit like the one Paul Whiffin does....although it's very slightly different i think. am looking at the Greddy one myself. Mine turned up this morning from Paul W, looks awesome, will be getting busy this week..!! Not sure what that one is , could be the C-West or Wings West Lip. Quote Link to comment Share on other sites More sharing options...
Ian W Posted March 14, 2006 Share Posted March 14, 2006 Mine turned up this morning from Paul W, looks awesome, will be getting busy this week..!! Not sure what that one is , could be the C-West or Wings West Lip. make sure you get pics up when it's done mate, think i'll get the Greddy replica but not sure as i don't have any side skirts....reckon it'll look pants? Quote Link to comment Share on other sites More sharing options...
SupraJames Posted March 14, 2006 Share Posted March 14, 2006 Yeah I got the replica as have a bit of a different plan with it Pics will go up once the project is complete, should be a couple of weeks. Dont think it will look pants, might just make the body look a little uneven as the front end will look lower than the sides. Quote Link to comment Share on other sites More sharing options...
Ian W Posted March 14, 2006 Share Posted March 14, 2006 can't wait to see it now.......a different plan, eh? hmmmmm dunno if it'll look uneven as i've seen other supes without skirts and with a lip and it looks okay. i've got rear spats as well, no skirts though!! Quote Link to comment Share on other sites More sharing options...
SupraJames Posted March 14, 2006 Share Posted March 14, 2006 Yeah should be different and hopefully a one off look..! Sounds like you need some skirts, personally I think the VS although common are the nicest looking skirts round, but the Bomex are nice to. Quote Link to comment Share on other sites More sharing options...
Ian W Posted March 14, 2006 Share Posted March 14, 2006 could well be right....all comes down to cash though unfortunately Quote Link to comment Share on other sites More sharing options...
SupraJames Posted March 14, 2006 Share Posted March 14, 2006 Yeah doesnt everything with Supras..! I am off to Abbey Motorsport tomorrow to have my boost controller sorted out as it was installed wrong..! More money I have to pay out and they are not a cheap place to go..! Quote Link to comment Share on other sites More sharing options...
Ian W Posted March 14, 2006 Share Posted March 14, 2006 ouch, good luck tomorrow then mate. hope it doesn't cost you too much. i'll look out for your pics and a few weeks time! Quote Link to comment Share on other sites More sharing options...
SupraJames Posted March 14, 2006 Share Posted March 14, 2006 Ok back to topic, its not the C-West lip, and the Wings West one looks just like the Greddy one..! http://www.wingswest.com/products_detail.asp?page=1&id=645 So none the wiser on what that lip is..! Sorry:rolleyes: Quote Link to comment Share on other sites More sharing options...
Ian W Posted March 14, 2006 Share Posted March 14, 2006 am sure it's the Whifbitz one, check out the other pics of it on the car in Mr T's garage. Quote Link to comment Share on other sites More sharing options...
SupraJames Posted March 14, 2006 Share Posted March 14, 2006 Its nice cause it does not have the side bits like the Greddy one..! Umm gives me more ideas..! Quote Link to comment Share on other sites More sharing options...
SatSport Posted March 14, 2006 Share Posted March 14, 2006 Looks similar to the one i have on.............. not a Whifbitz item tho`. ??? http://img93.imageshack.us/img93/1577/frontsupside9yu.jpg Quote Link to comment Share on other sites More sharing options...
dangerous rep Posted March 14, 2006 Author Share Posted March 14, 2006 didnt realise id get this much reply lol. the one above do you know what tha is?? it does look the same as the original one i posted up. im not a fan of the greedy one it looks to flat if that makes sence, it doesnt match the original bumper as much as i would like it to. my favourite splitter is the amuse one but i been trying for 8 months now to find one!! it just suits the standard (optional) jap skirts and spats Quote Link to comment Share on other sites More sharing options...
SatSport Posted March 14, 2006 Share Posted March 14, 2006 didnt realise id get this much reply lol. the one above do you know what tha is?? iirc i got this from an outfit called `crazybodykits.com`, west midlands. They used to sell kits on Ebay. I`d be inclined to go for the polyurathene type tbh, the `glass will crack at some stage. Quote Link to comment Share on other sites More sharing options...
dangerous rep Posted March 14, 2006 Author Share Posted March 14, 2006 yeah heard this from alot of people. just wished they did the amuse splitter in polyurathene cheers for the link ill take a look Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.