View Full Version : TOAD ALARM.Ai606 Problem
Had a 606i fitted at sextons, but they disconected my Turbo timer (greedy one), does anyone have a diagram of how to put it back on. its got a loom on it that i assume plugs in under the dash by the bottom of the steering wheel, but there are a few wires that have been cut, that Im not sure where they have come from.
Matt Harwood
24-03-05, 08:10
Unless you asked them to take it off, why don't you take it back there and ask them to re-connect it?
They told me that they couldn't fit the alarm with it on?
Some cat1 imobiliser systems don't work properly with turbo timer circuits.
I got my GT4 turbo timer disconnected when I got a AI606 alarm fitted. The guy said that the imobiliser simply would get confused if there was a turbo timer signal operating.
The AI606 imobiliser circuit arms itself after something like 30sec after pressing the key fob.... the installer guy told me that it screws things up if both the imobiliser and turbo timer are working at the same time.
Dunno if that helps.
I had the same alarm fitted. i have a HKS turbo Timer - They both work fine! Obviously need to wait till the engine cuts out before arming the alarm
you can have a turbo timer fitted with a toad ai606 alarm, but you will have to wait till the engine shuts down before you can arm the car.
But if you need a cat1 thatcham approved alarm fitted to your car for insurance purposes, then fitting a turbo timer will be an issue.
A turbo timer is not a thatcham approved product and will invalidate a cat1 status of the alarm.
vBulletin® v3.7.3, Copyright ©2000-2008, Jelsoft Enterprises Ltd.