coza Posted August 14, 2017 Share Posted August 14, 2017 Hi Checked my car on the weekend and noticed this I cleaned up used the car again the following day and it back, When the car idles it's close to stalling any ideas ? Quote Link to comment Share on other sites More sharing options...
fastcar Posted August 14, 2017 Share Posted August 14, 2017 Blocked cam breathers maybe! Quote Link to comment Share on other sites More sharing options...
Mike2JZ Posted August 14, 2017 Share Posted August 14, 2017 Do a compression check asap Quote Link to comment Share on other sites More sharing options...
Frank Bullitt Posted August 14, 2017 Share Posted August 14, 2017 When did you last drain the catch can? That air filter looks saturated. Quote Link to comment Share on other sites More sharing options...
Ric Posted August 14, 2017 Share Posted August 14, 2017 tank maybe full? Quote Link to comment Share on other sites More sharing options...
Chris Bailey Posted August 14, 2017 Share Posted August 14, 2017 As above do a compression check, that's not good really. Is the car smoking under load? Has the clear pipe next the catch tank got oil in it? Or any signs of residue? Quote Link to comment Share on other sites More sharing options...
coza Posted August 14, 2017 Author Share Posted August 14, 2017 Catch can is new and has a level on it which is showing empty , the rocker cover an fittings are new doing a compression test and pvc on Thursday , has anyone changed piston rings and how much is labour ? Quote Link to comment Share on other sites More sharing options...
coza Posted August 14, 2017 Author Share Posted August 14, 2017 Car is not smoking , took it to the garage today idle was good and underload the car drives nice without any smoke Quote Link to comment Share on other sites More sharing options...
coza Posted August 15, 2017 Author Share Posted August 15, 2017 So an update so far , checked compression on cylinder 1,2,4,5 and no issues there all very similar couldn't check 3 and 6 they had rounded screws on the coil so will attempt them tomorrow - - - Updated - - - Quote Link to comment Share on other sites More sharing options...
berg Posted August 15, 2017 Share Posted August 15, 2017 You say the rocker cover -an fittings are new Sounds silly but were the baffles re-installed? I seen a thread on supraforums ages ago where the guy had the baffles removed (rivets drilled out) to weld -an fittings on and never reinstalled them as he didnt want to drill and tap He had the same issue Quote Link to comment Share on other sites More sharing options...
Swampy442 Posted August 15, 2017 Share Posted August 15, 2017 PCV valve. Quote Link to comment Share on other sites More sharing options...
coza Posted August 15, 2017 Author Share Posted August 15, 2017 the AN fittings has had the baffles installed Quote Link to comment Share on other sites More sharing options...
coza Posted August 16, 2017 Author Share Posted August 16, 2017 Update all cylinders are looking good , catch tank it empty , I have no pcv valve on the rocker cover , Running out of ideas Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.