TRD3000GT Posted February 24, 2005 Share Posted February 24, 2005 I am about to get some new 19" wheels that have 315's on the rear Can anyone think that this will be a problem? I know the rear arches need to be slightly trimmed/rolled. Anoyone know where I can get this done? Quote Link to comment Share on other sites More sharing options...
Fifty Posted February 24, 2005 Share Posted February 24, 2005 Dude Quote Link to comment Share on other sites More sharing options...
Supragal Posted February 24, 2005 Share Posted February 24, 2005 Don't be a poof. Get 335's Quote Link to comment Share on other sites More sharing options...
TRD3000GT Posted February 24, 2005 Author Share Posted February 24, 2005 Shut it SG... Im doing this without a wide body remember! These are the WIDEST I can get on + they are costing me both arms and both legs! Quote Link to comment Share on other sites More sharing options...
tbourner Posted February 24, 2005 Share Posted February 24, 2005 These are the WIDEST I can get on + they are costing me both arms and both legs! Gonna be tricky to drive!!! Quote Link to comment Share on other sites More sharing options...
AJI Posted February 24, 2005 Share Posted February 24, 2005 Blimey 315's. Are you going to balance these with wider fronts aswell? Otherwise you'll have a car that only understeers. Its ok if you like it like that though. Quote Link to comment Share on other sites More sharing options...
Supragal Posted February 24, 2005 Share Posted February 24, 2005 I'm only playing. Loads of places can roll arches- bodyshop or even some tyre fitting places can do it. It will surely depend on offset but if it needs to be cut to allow them to fit how will that work without extra arch bits? Quote Link to comment Share on other sites More sharing options...
Thorin Posted February 24, 2005 Share Posted February 24, 2005 Trimmed and rolled arches a must on that wide a tyre. Seriously though if you're really gonna go that wide I'd use an 18" wheel at most. Quote Link to comment Share on other sites More sharing options...
MONKEYmark Posted February 24, 2005 Share Posted February 24, 2005 you can fit 315x35x17 drag radials on stock rims. i had my arches rolled by dude. when i first got car it used to bang over bumps when you put your foot down. it was fooking rear tyres up. sussed it out to be wrong offset wheels. they were sticking out too far. what sort of prices are street rubber that size. im on 285 rubber in rear and you limited a bit who make tyres that wide in 17" go to 18" or 19" and you have more chioce and also cheaper too. Quote Link to comment Share on other sites More sharing options...
Gough Posted February 24, 2005 Share Posted February 24, 2005 I am about to get some new 19" wheels that have 315's on the rear Can anyone think that this will be a problem? I know the rear arches need to be slightly trimmed/rolled. Anoyone know where I can get this done? No offence intended, but won't this ruin the handling? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.