cainhead Posted June 2, 2016 Share Posted June 2, 2016 Hello, Just trying to refit my UEGO Sensor with my new single setup and need to ask a little help. Previously I had a decat pipe that ran straight off the manifold and did the job of 1st and 2nd decat in one pipe. So need to by a new second decat pipe, but before I get the bung welded in can some one tell me if it's possible for the sensor to go in the downpipe. I only ask as the is already a spot welded in on the down pipe with a blocking screw in. It's just past the O2 sensor so about 6 inches from the turbo. The AEM instructions say 18 or 36 inches from the exhaust port but then states for turbo vehicle to be after turbo but before the cats. Any ideas Cheers Quote Link to comment Share on other sites More sharing options...
TT Paul Posted June 3, 2016 Share Posted June 3, 2016 Its fine just put it there mines in there. Just make sure you have room for the sensor as it sticks out a bit Quote Link to comment Share on other sites More sharing options...
cainhead Posted June 3, 2016 Author Share Posted June 3, 2016 Okay cool thanks for replying. One more question to anyone who can help. I have also some sort of electrical connector coming of the single turbo but the installation instructions doesn't say a thing about it. Any ideas Cheers Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.