Jump to content
The mkiv Supra Owners Club

1993 J-Spec NA Auto, with goodies


Richie_k83
 Share

Recommended Posts

So it's a hard choice but I am putting her up for sale. Purchased last May from Forum member Shaun Preece.

 

Located in West Midlands

 

I would appreciate if people can refrain from telling me how much they think it's worth or asking me to break it. I'm not in a rush to sell and given the age and value of the parts alone, I think the price is very reasonable.

 

1993 J-Spec NA Auto

 

138,014 miles (mix of miles & km I believe)

 

Mot'd till 22nd May 2016

 

Scorpion Alarm & Immobiliser

 

The car has undergone a fair chunk of work since I brought her. She's my daily so expect the miles to go up!

Overall body condition, well, it's got the usual dinks, dents, scratches and stone chips of a car it's age and drivers wing is starting to fade slightly.

The engine is solid, recently had the flex plate replaced as it had broken and was causing a noise.

Whilst the engine was out, all seals and gaskets were changed apart from the head gasket. Along with the upper and lower sump being re sealed. Auto box shaft seals were replaced also.

 

I have plenty of receipts and MOT certificates from previous owners.

 

Engine has been fully serviced a few months back with HKS Oil, HKS Oil Filter, HKS Spark Plugs, HKS Air Filter, Cam-belt Kit, Auxiliary Belt, Auxiliary Idler Pulley/bearing, Engine Coolant, Distributor Cap, Rotor Arm, Fuel Filter, Fresh Auto Box Oil & new battery. Compressions Checked and Timing Set up.

 

Engine;

 

Standard apart from green vacuum hoses

AirCon System Removed

HKS Induction kit (still have oem air box with HKS panel filter)

 

Exhaust;

 

HKS Silent Hi-Power Stainless Cat back system

 

Transmission;

 

Standard Auto with modified Pajero side mounted oil cooler

 

Brakes;

 

Lexus 4 Pot front Calipers with new discs & Pads

J-spec rear Calipers with new pads

Hel hoses braided brake lines

AP Racing fluid

 

Suspension;

 

Tein street flex coilovers

Tein EDFC II Electronic Dampening Controller

Whiteline 30mm heavy duty front adjustable sway-bar

Whiteline heavy duty adjustable front drop links

Whiteline 20mm heavy duty rear adjustable sway-bar

Whiteline heavy duty adjustable rear drop links

 

Body;

 

Standard Body

Cusco Safety 21, 5 point roll cage with safety 21 additional harness / strut bar

Tinted front indicators

Painted inside of headlamps black

Wheel arches and floor waxoyled

Rear wiper removed (still have it)

Rear wing removed (holes covered with black film)

 

Interior;

 

Rear seats removed with side trims for cage (still have the trims)

Fire proof Cage padding

Arm rests trimmed with black suedette

Tailored floor mats

Roof lining and carpet dyed black

Nardi Personal steering wheel

Vibe speakers

Sony MP3 head unit

Standard Seats with seatbelt

 

Wheels & Tyres;

 

Brand New Japan Racing 18" JR10 wheels (Staggered fitment)

New Toyo Proxes T1-R Front Tyres

Dunlop Sport Rear Tyres

Rays Durloc wheel nuts with matching lock nuts

Rays valve caps

 

Bad bits;

 

Usual marks with age/mileage

Centre console arm rest lid, hinge broken

Dash and doors painted red by previous owner (up to you if that's good or bad)

Electric aerial doesn't work

Front splitter cracked and tied up with a cable tie stitch

Gear stick loose, needs changing

 

Pics;

 

http://images.tapatalk-cdn.com/15/12/29/65ff74e7b5ffc806253ef2815f0a78f6.jpg

http://images.tapatalk-cdn.com/15/12/29/c9031f7f992359a2ca77d16d1303f648.jpg

http://images.tapatalk-cdn.com/15/12/29/fb745b2c7d7ac42e2ebfacb3a76b1245.jpg

http://images.tapatalk-cdn.com/15/12/29/36c74779f7571e576bf716281c4f97e7.jpg

http://images.tapatalk-cdn.com/15/12/29/3614625573fb96340b50bd4654c52026.jpg

image

image

 

Price, £4,750 ono

 

Viewing welcome, Pm for more info.

Link to comment
Share on other sites

  • 4 weeks later...
  • 1 month later...
Hi

Do you still have the back seats? How is the cage fitted? Would it be easy to remove?

 

Hi Ian,

 

I don't have the rear seats or seat-belts i'm afraid.

 

The roll cage has a diagonal brace and wont allow fitment of the seats.

 

The cage is bolted into place with 16x bolts.

 

I would be happy to remove it and reduct the price if you were genuinely interested.

 

Let me know.

Link to comment
Share on other sites

Hi Ian,

 

I don't have the rear seats or seat-belts i'm afraid.

 

The roll cage has a diagonal brace and wont allow fitment of the seats.

 

The cage is bolted into place with 16x bolts.

 

I would be happy to remove it and reduct the price if you were genuinely interested.

 

Let me know.

 

You have a PM

Link to comment
Share on other sites

 Share

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. You might also be interested in our Guidelines, Privacy Policy and Terms of Use.