Supradk Posted September 15, 2014 Share Posted September 15, 2014 Hi guys Got my supra back today and hold my new low level spoiler from whifbitz up against the boot. It has 15mm air in the middle and a bit hard to push down. Same with yours? What did you do to push it down and what products did you use to fasten it? Tape or glue? Quote Link to comment Share on other sites More sharing options...
jcbt Posted September 15, 2014 Share Posted September 15, 2014 Just pm Paul at Whifbitz he has fitted quite a few - think mine is held by a self tapper screw in the middle and glued out wards to ends Quote Link to comment Share on other sites More sharing options...
jay200bhp Posted September 15, 2014 Share Posted September 15, 2014 has it got a bit of a david BOWie on? Quote Link to comment Share on other sites More sharing options...
Supradk Posted September 16, 2014 Author Share Posted September 16, 2014 Will try and ask Paul Quote Link to comment Share on other sites More sharing options...
Al Massey Posted September 16, 2014 Share Posted September 16, 2014 Mine sat up in the middle a bit. I got my dad to help me fit it. I put tiger seal on in, then lined it up, pressed down hard in the centre and my dad used duct tape all over, then I placed some weights in the centre and used more tape. Left over night, came back in the morning and it was perfect. Quote Link to comment Share on other sites More sharing options...
Supradk Posted September 16, 2014 Author Share Posted September 16, 2014 Looking good with the duck tape on will take some duck tape from my work tomorrow and make it fit Quote Link to comment Share on other sites More sharing options...
Al Massey Posted September 16, 2014 Share Posted September 16, 2014 I did a test run first without the tiger seal, just to make sure I could line it up right and that the duct tape will hold. Quote Link to comment Share on other sites More sharing options...
Supradk Posted September 16, 2014 Author Share Posted September 16, 2014 what do you mean by a test run? with tiger seal you mean a kind of glue that looks like silicone? Quote Link to comment Share on other sites More sharing options...
Al Massey Posted September 16, 2014 Share Posted September 16, 2014 I did a test fit using duct tape and no glue/tiger seal, just to make sure I could get it to sit right and the duct tape to hold and when I was confident I took it off and added the tiger seal. Yeah, it's just a silicone sealant. Quote Link to comment Share on other sites More sharing options...
Supradk Posted September 16, 2014 Author Share Posted September 16, 2014 thanks for the info mate best to ask other people that have done the fit before doing it myself Quote Link to comment Share on other sites More sharing options...
Al Massey Posted September 16, 2014 Share Posted September 16, 2014 thanks for the info mate best to ask other people that have done the fit before doing it myself No worries bud. Try and do a test fit first like I did just so you know the tape will hold and it's easier to take a step back and judge if it's taped down before the glue Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.