scott87 Posted November 7, 2013 Share Posted November 7, 2013 Ok so i have got an intercooler that is 2.5" in and out. Im going to use 2.5" piping so i can go through the wing then 3" to the turbo itself. Has anyone actually taken measurements of pipe needed silicone joiners, amount of couplers needed etc etc. Had a look at some photos and thats helped a bit but a really indepth few would be good of one car or something Thanks in advance Quote Link to comment Share on other sites More sharing options...
Fly Posted November 7, 2013 Share Posted November 7, 2013 (edited) Scott there's quite a few different ways to do it. It depends if you use 90 degree/ 180 degree pipe bends or straight pipe and silicone joiners. Let me dig through my pm's as I sent lots of pics to balls deep when he was doing his. No measurements though. Pm sent with pics Edited November 7, 2013 by Fly (see edit history) Quote Link to comment Share on other sites More sharing options...
berg Posted November 7, 2013 Share Posted November 7, 2013 I found it easier to go down behind the headlight than through the wing 85mm hole saw needed though Quote Link to comment Share on other sites More sharing options...
scott87 Posted November 7, 2013 Author Share Posted November 7, 2013 Im using 2.5" so i can go down through the wing. I want to use as much metal pipe as possible and then joiners. But im hapy for the joiners to be the bends.... Quote Link to comment Share on other sites More sharing options...
Noz Posted November 7, 2013 Share Posted November 7, 2013 I sent 3" through the wing. Quote Link to comment Share on other sites More sharing options...
buster Posted November 7, 2013 Share Posted November 7, 2013 I sent 3" through the wing. Your such a bad ass Quote Link to comment Share on other sites More sharing options...
Noz Posted November 8, 2013 Share Posted November 8, 2013 Your such a bad ass Had to use a hammer though for 3". Be warned. Only bad ass mofo's know how to operate such equipment. Quote Link to comment Share on other sites More sharing options...
listy Posted November 8, 2013 Share Posted November 8, 2013 I sent 3" through the wing. You are amazing Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.