berg Posted August 6, 2013 Share Posted August 6, 2013 Just finished my NA-T build but i need to extend one of the o2 sensor wires so it reaches the new downpipe I have the single wire o2 sensors which have one single silver strand covered by lots of copper looking wire. Can anyone poiunt me in the right direction to which wire i can use to extend this as im guessing normal wire will be no good as it looks different Cheers Quote Link to comment Share on other sites More sharing options...
Rich.2211 Posted August 6, 2013 Share Posted August 6, 2013 Good question, I'm about to do a similar thing but wire two O2 sensors into one. Interested to see the answer Quote Link to comment Share on other sites More sharing options...
Swampy442 Posted August 6, 2013 Share Posted August 6, 2013 As long as you use the same gauge of wire and a good quality connection there will be no issues. Quote Link to comment Share on other sites More sharing options...
Nic Posted August 6, 2013 Share Posted August 6, 2013 I'd use an old sensor wire, solder them together then shrink wrap. Quote Link to comment Share on other sites More sharing options...
Noz Posted August 6, 2013 Share Posted August 6, 2013 To get you out a hole, even use two smaller wires to get the same amount of wire for them. Only do this if your 100% in a hole. Make sure you tie the new wire out the way or the solder will re-melt on the downpipe and break off, I've seen it happen. Quote Link to comment Share on other sites More sharing options...
berg Posted August 6, 2013 Author Share Posted August 6, 2013 Thanks for the tips guys In the end i just extended the wire for the main plug and moved the plug closer to the downpipe Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.