Samsar Posted May 4, 2013 Share Posted May 4, 2013 I've just got myself some new seats that I'm planning on fitting over the weekend. I'm just wondering about the best way of cleaning them before I fit them. Is it possible to strip them down to give them a good scrub or best to leave them intact and clean them that way? These are the seats in question. Quote Link to comment Share on other sites More sharing options...
DaveR Posted May 4, 2013 Share Posted May 4, 2013 The covering material (whatever it is) on aftermarket seats is a REAL pain in the obvious to clean. Even my uber-powerful Bosch vacuum cleaner struggles to get the dusty stuff off. Not helpful, but know that I feel your pain... Quote Link to comment Share on other sites More sharing options...
Samsar Posted May 5, 2013 Author Share Posted May 5, 2013 The covering material (whatever it is) on aftermarket seats is a REAL pain in the obvious to clean. Even my uber-powerful Bosch vacuum cleaner struggles to get the dusty stuff off. Not helpful, but know that I feel your pain... Apparently they've been sat in a barn for a while so most of it is just dusty Once I've got them done I'll possibly be selling the leather seats I'm taking out. Quote Link to comment Share on other sites More sharing options...
Pig Posted May 5, 2013 Share Posted May 5, 2013 Exercise caution! I would say they need a wet vac to bring hem back to life Quote Link to comment Share on other sites More sharing options...
j_jza80 Posted May 5, 2013 Share Posted May 5, 2013 I'd stick with leather IMO, they really won't suit the interior of a Supra. (unless you get them trimmed in leather first) Quote Link to comment Share on other sites More sharing options...
Guest Budz86 Posted May 5, 2013 Share Posted May 5, 2013 Wet vac or interior shampoo. The autoglym stuff works well; just need to apply and rub lightly with a clean brush Quote Link to comment Share on other sites More sharing options...
Marco79 Posted May 5, 2013 Share Posted May 5, 2013 Is that like an alcantara centre? If so there is specific cleaners out there for this bit test on a none visual bit first as even these have been known to screw the material up in the past Quote Link to comment Share on other sites More sharing options...
Samsar Posted May 5, 2013 Author Share Posted May 5, 2013 It's just a normal material centre . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.