ballsdeep Posted May 3, 2013 Share Posted May 3, 2013 So I was planning on fitting my engine back in at the weekend until I started to think about what I would need for the job, so I started to search for torque settings for the flywheel which I found to be 49nm + 90 degrees (correct me if I'm wrong) it then struck me that I can't re-use the flywheel bolts.. is this true? Where would I be able to buy new bolts from at such short notice? Also are the clutch pressure plate bolts high tensile? Iv lost one.. Looks like I'm getting nothing done this weekend, which means I get to spend quality time with the misses yippee Quote Link to comment Share on other sites More sharing options...
mplavery Posted May 3, 2013 Share Posted May 3, 2013 .... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.