Greddy Inlet Manifold Pictures

Has anyone got any close up pictures of the greddy inlet manifold fitted & plumbed in ?

Im interested in the areas i have circled on the below picture. Can anyone help ?

http://img831.imageshack.us/img831/8315/41054133.jpg

Cheers, Moo.

On the right the plug is the stock Intake air Temp sensor, the vacuum/boost point can be anything you want. The centre is a random vacuum /boost take off. On the left, (From the right) Idle air control valve take-off, Brake master vacuum booster take-off, and the oter two are whatever you want them to be. I have never seen them used personally, no need.

Thank you ! So...

-Stock Intake air Temp sensor = Next to number 2 on that above picture ?

-Vacuum/boost point = Number 2 on that above picture ?

-The centre is a random vacuum /boost take off.

-Idle air control valve take off = Number 3. ?

-Idle air control valve take off = Number 5. ?

-Number 4's are whatever needed.

So, typically a bpu supra running this inlet would use numbers 5,3,2 and one of the vac points?

If its a stock bpu car the lower vac line is used as well. Goes to the valve for the charcole canister

Use 1 or the one close to it for map sensor and fpr

Use 2 for cam breather and intake temp sensor

Use 3 for idle control valve

Use 4 for extra things like boost gauge ect but I usually blank them

The one at the front you havnt circled goes to the power steering

The lower one is for charcole canister valve.

Thanks Lee !! Very helpful information.

Whats number 5, Brake master vacuum booster take-off? (I think thats what Turtleshead said going from the right side)