Auxiliary pulley torque ?

Hi all,

I just order U.R. Lightweight Pulley kit (except crank but including idler pulley).

I wonder what torque install those ?

Didn't t find out yet !

Thanks all

You should find the answer in here

http://www.turbosupras.com/pages/en/pages/specifications/JZA80/a80tsrm.htm

Best to find out and post them up here for the future...

Everythings in the WSM, you only have to look

So!

For the alternator pulley :

4. INSTALL PULLEY

(a) Install the pulley to the rotor shaft by tightening the pulley nut by hand.

(b) Hold SST (A) with a torque wrench, and tighten SST (B) clockwise to the specified torque.

SST 09820–63010

Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)

© Check that SST (A) is secured to the pulley shaft.

(d) Mount SST © in a vise.

(e) Insert SST (B) into SST ©, and attach the pulley nut to

SST ©.

(f) To torque the pulley nut, turn SST (A) in the direction

shown in the illustration.

Torque: 110.5 N·m (1,125 kgf·cm, 81 ft·lbf)

(g) Remove the generator from SST ©.

Power steering pulley . 2JZ–GTE:

INSTALL SUCTION PORT UNION

(a) Coat a new O–ring with power steering fluid and install it to the union.

(b) Torque the bolt.

Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)

. 2JZ–GTE:

INSTALL VANE PUMP PULLEY

Using SST to stop the pulley rotating, torque the nut.

SST 09960–10010 (09962–01000, 09663–01000) Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)