Jump to content
The mkiv Supra Owners Club

Correct fitting of oem spats


linconhawk
 Share

Recommended Posts

Had a search but not much detailed info came up....

 

Is there a correct / good way of attaching oem spats ?

 

I have some fitted, but they are coming away... I was going to take them off and re-fit them.

 

I am aware there are several screws, but how do you get them to fit flat against the bumper... Do you use tiger seal or something, if so, how would you hold / keep pressed into place untill set ?

 

Any help would be appreciated....

Link to comment
Share on other sites

Doublesided foam tape that you get from your local paint suppliers is the stuff to use. If all surfaces are cleaned properly before fitting then nothing will remove it, unless you vehemently need it off, then it comes apart at the foam section and you simply use glue softener to remove the sticky remains. Most cars body mouldings are secured in the very same way.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. You might also be interested in our Guidelines, Privacy Policy and Terms of Use.