drift_bear Posted January 24, 2012 Share Posted January 24, 2012 I'm looking at fitting my AFR gauge tomorrow at last and like usual ill be doing it all myself. Was wondering how much others have done this and if its an easy enough job to do? It will be located into the air vent next to where the clock would be (now where my boost gauge sits) so what's the best way to run the harness down to the boss and also where to put the boss on the exhaust? Quote Link to comment Share on other sites More sharing options...
Scott Posted January 24, 2012 Share Posted January 24, 2012 If you want to do a proper, and easy, job then it's best to take the wheel off and the inner arch liner of the drivers side. With that out of the way you can easily get to the grommet to feed it through from behind the pedals. Quote Link to comment Share on other sites More sharing options...
fastcar Posted January 24, 2012 Share Posted January 24, 2012 (edited) If you have a j spec you can remove the heat sencer from the cat (just cut the wires to the heat sencer and insulate them well) then feed the cable up through the hole and under the carpet but it can be a bit hard if you dont have a cable feeder. Im sure i mounted my sencer just after the 2nd decat. Im sure you have to get the bung weilded to the exhaust aswell so you can screw the sencer into it thats what i did anyways Edited January 24, 2012 by fastcar (see edit history) Quote Link to comment Share on other sites More sharing options...
Rob W Posted January 24, 2012 Share Posted January 24, 2012 Yea as above, had the bung welded next to the flange on the 2nd decat where it meets the first. The whole in the tunnel is right next to where the decats meet. All you have to do then is wire up and 12v ignition feed and ground. I put mine where the clock is as it fits perfectly. Quote Link to comment Share on other sites More sharing options...
merckx Posted January 24, 2012 Share Posted January 24, 2012 The whole in the tunnel is right next to where the decats meet. All you have to do then is wire up and 12v ignition feed and ground. I put mine where the clock is as it fits perfectly. Yes, there's a handy grommet on the left of the tunnel very close to where I fitted the sensor. Quote Link to comment Share on other sites More sharing options...
fastcar Posted January 24, 2012 Share Posted January 24, 2012 yep thats where i put my gauge too. you can then use the 12v ignition and ground that used to go to the clock. I had to also find someone that could weld stainless steel. I got a good old boy at a local machine shop to do it as the exhaust centre's by me wouldnt do it Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.