dr_jekyll Posted July 27, 2011 Share Posted July 27, 2011 does anybody know the thread an pitch of the eyes required for the supe. the 2 stadard seatbelt holes either side of the seat and the holes at the back of the car that the rear seat back would bolt too, thanks Quote Link to comment Share on other sites More sharing options...
neilthenut Posted July 28, 2011 Share Posted July 28, 2011 should be able find out next couple of days for ya. Quote Link to comment Share on other sites More sharing options...
Chris Wilson Posted July 28, 2011 Share Posted July 28, 2011 Even Jap cars often use a UNF thread size for seat belt anchors, so be careful. Common size is 7/16 UNF, but check with a bolt or thread gauge. Quote Link to comment Share on other sites More sharing options...
pedrosixfour Posted July 28, 2011 Share Posted July 28, 2011 As far as I can remember the bolts that hold the actual seat belt reels are 7/16" UNF. The bolts that hold the receivers are M10 x 1.25mm. I tapped the M10 holes out to 7/16" UNF on my car because the harness eye bolts are 7/16" UNF. Theres no need to drill, just run the proper tap through. Quote Link to comment Share on other sites More sharing options...
Chris Wilson Posted July 28, 2011 Share Posted July 28, 2011 Most aftermarket "seat belt anchor eyes" are actually machinery lifting rings and available in a wide range of male and female thread forms, and eye size. Quote Link to comment Share on other sites More sharing options...
dr_jekyll Posted July 28, 2011 Author Share Posted July 28, 2011 great, thanks for the input gents Quote Link to comment Share on other sites More sharing options...
pedrosixfour Posted July 28, 2011 Share Posted July 28, 2011 Most aftermarket "seat belt anchor eyes" are actually machinery lifting rings and available in a wide range of male and female thread forms, and eye size. Tis true, but mine will never return to the road so I can do these crazy things. I even removed the original cross members that the front seats bolt to and replaced them with 1" box section for some extra headroom! Quote Link to comment Share on other sites More sharing options...
dr_jekyll Posted July 28, 2011 Author Share Posted July 28, 2011 Tis true, but mine will never return to the road so I can do these crazy things. I even removed the original cross members that the front seats bolt to and replaced them with 1" box section for some extra headroom! you rebel Quote Link to comment Share on other sites More sharing options...
pedrosixfour Posted July 28, 2011 Share Posted July 28, 2011 you lanky streak of piss This is more the reason to be honest. Quote Link to comment Share on other sites More sharing options...
dr_jekyll Posted July 28, 2011 Author Share Posted July 28, 2011 im the same boat mate , im 6ft 4 and with my lid on its pretty tight. i had seat mounts made that tilt the seat to get me down lower Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.