Jump to content
The mkiv Supra Owners Club

600BHP + 75lb - 780cc Precision Low impedance Top feed injectors AS NEW


spiderpigcity
 Share

Recommended Posts

[ATTACH]131848[/ATTACH]

I ordered these a while back, fitted them to the car, turned it over to make sure the setup was running ok on the base MAP, turned the car back off. went to the tuner, he said go for 1000cc as it would suit my setup better. so we took them out and here they are for sale. They havnt even done 1 mile!

 

I will send them next day special delivery

 

good for 500-600 bhp with the right setup.

 

LOW IMPEDANCE, Flowed at 43.5 psi, Domestic type 14mm dia rail side.

 

will fit Boost Logic Fuel Rail, WOTM Fuel Rail, SP Fuel Rail, and the Titan Fuel Rail and others, or any fuel rail with 14mm top feed inlets.

 

they cost around $700 with shipping and import tax, so are a bargain, with no hassle with customs.£225. posted with £500 insurance

 

Delphi 75lb/hour 750cc low impedance fuel injector:

 

Genuine Delphi 75 lb/hour Low Impedance Injectors

 

These injectors flow 750 cc/min at 43.5 PSI ( 3 BAR ). Some websites may refer to their flow rating as 75 lb/hr or 750/780 cc/min Delphi Peak and Hold or Low-Z Injectors. These high flow injectors offer an excellent spray cone and very good response but should not be pushed to very high static rail pressures.

 

These injectors offer excellent response and atomization but should not be run at excessive rail pressures due to the disc design. Higher rail pressures with boosted / supercharged applications are acceptable with a pressure referenced fuel regulator because the pressure differential remains unchanged.

 

FEATURES:

Genuine, reliable, new Delphi Injectors

Excellent response characteristics

Robust Design

Low Impedance

ADVANTAGES:

The flat mating surface ensures that no excess fuel is present to evaporate and therefore, no deposits or clogging can occur.

Long service life

High-speed disc action allows wider dynamic flow range for improved idling

Quiet operation

Revolutionary disc design resists build up deposits which can affect fuel flow

No Fuel leakage for quicker starts

Specifications:

Coil Resistance: 2 Ohms / Low Impedance

Static Flow Rate @ 43.5PSI ( 300kPa ) w/Gas: 750 cc/min = 75 lb/hr = 12 gm/s

Connector: Bosch EV1

Ball & Seat / Disc design with 6 Hole orifice

Equivalent Part Numbers:

Delphi 17113742

 

Manufactured by: Delphi

Link to comment
Share on other sites

  • 1 month later...
  • 2 weeks later...
  • 1 month later...
  • 3 weeks later...
  • 1 month later...
 Share

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. You might also be interested in our Guidelines, Privacy Policy and Terms of Use.