sterring wheel removal snap off

What size allen key or tool is used to remove the steering wheel from the hub, I want to change the kit to a worksbell rafixII

I tried a few llen keys, they are either a frction too small or large

thanks

Just using this pic for illustration purposes, I presume they are all the same fittings

http://sphotos.ak.fbcdn.net/hphotos-ak-snc4/hs615.snc4/59566_1265464656742_1833547789_544479_8267_n.jpg

They look like Torx bolts not Allen bolts. Take a closer pic and I will confirm

most are 5 mm but the ones you have could be imperial mate

You get metric & imperial size allen keys. If you have metric try imperial or vice versa.

Updated the Pic

Just checked they where imperial Allen keys, will try get Metric

Ok, they are definitely Allen but you have (or maybe from before) rounded them quite badly.

Ok, they are definitely Allen but you have (or maybe from before) rounded them quite badly.

I never took the wheel off, they where like that when I got the car, but thats what I am afraid of

they are allen bolts, if these are rounded, and are 5mm, use a torx 35 to remove them.

they are allen bolts, if these are rounded, and are 5mm, use a torx 35 to remove them.

Thanks will do, Just want to have the new Works Bell kit in my hands before I attempt to swap the wheel over

Let me know how you get on Carlo. If your still stuck sunday (japfest) i'll bring up torx & allen keys & give you a hand if you like?

Let me know how you get on Carlo. If your still stuck sunday (japfest) i'll bring up torx & allen keys & give you a hand if you like?

Cheers Rab, just want to ask my stupid Q's becasue as u notice they look very gunttered

Just wanted to make sure

Cheers Rab, just want to ask my stupid Q's becasue as u notice they look very gunttered

 

Just wanted to make sure

you know what they say "where there's a will there's a way".

I also have a hammer, chisel & consaw