Jump to content
The mkiv Supra Owners Club

Tearing apart stock seats


krisso_pl
 Share

Recommended Posts

Pretty simple fella, take them out than just look at them for a bit and its self explanatory. Look at the rear of the seat and you will see two zips, the lever for the seat tilt is two allan key bolts and then this comes off. Pop the plastic switch knobs off these are easy to do. Then you have philips screws holding on the side trim.

 

Now remove the plastics off the opposite side, once thats done unzip the rear cover iirc the bottom is clipped over a bar. You can now start removing covers. For the base cover its also clipped on iirc. Off the top of my head the head rests are removed by releasing the clips inside the back of the seat.

Hope this helps you.

Link to comment
Share on other sites

The headrest has 2 clips 1 at each side. Unzip the back & get your hands under the foam right up under the black thing that pops out on 1 side (same place on other side). It only has 1 groove in the bar at each side so when it moves a little it will just pull straight out.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. You might also be interested in our Guidelines, Privacy Policy and Terms of Use.