Guest RX-2jz Posted May 24, 2004 Share Posted May 24, 2004 i've done my searches and didn't find a post that just straight out tells the diameter of the restrictor ring. i'm in the US and need a ring asap...so i was just going to make one. the engine is a j-spec that has been installed in FD Rx-7. the twins are only going to be on for a very short while until the single arrives, but i don't want to worry about boost creep while they are on. can somebody tell me a good size to start with? thanks, mikey Quote Link to comment Share on other sites More sharing options...
Jake Posted May 24, 2004 Share Posted May 24, 2004 Hi Mikey, I've got one in my glovebox, gimme a couple of mins and I'll measure it. BRB....... Quote Link to comment Share on other sites More sharing options...
Jake Posted May 24, 2004 Share Posted May 24, 2004 52mm or 2'' near as dammit. I believe you Merkins like your measurements in inches, right? Quote Link to comment Share on other sites More sharing options...
Guest RX-2jz Posted May 24, 2004 Share Posted May 24, 2004 Originally posted by Jake 52mm or 2'' near as dammit. I believe you Merkins like your measurements in inches, right? haha thanks man!...that was fast! yeah inches would be the norm over here. i don't like it, but i guess i gotta use it thanks again, mikey Quote Link to comment Share on other sites More sharing options...
Jake Posted May 24, 2004 Share Posted May 24, 2004 Originally posted by RX-2jz haha thanks man NP Hey Mikey, come back and let us see some pics of this Supra powered RX when it's done! Quote Link to comment Share on other sites More sharing options...
defcom Posted May 26, 2004 Share Posted May 26, 2004 how the F do you fit a supra power block into a RX7??????? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.