Ewen Posted February 3, 2010 Share Posted February 3, 2010 I've a two gauge pillar pod, rain water is dripping from the lower pod gauge hole....Anyone had similar ? If so, did you find out where it was getting in ? There are no obvious holes / splits in the external window seals etc. Advice as always, much appreciated. Quote Link to comment Share on other sites More sharing options...
Matt H Posted February 3, 2010 Share Posted February 3, 2010 Maybe your drivings window is not set high enough to make the perfect seal when you wind the windows up, that would explain how water was getting behind you A-Pillar pod and running down the bottom. Might be worth a try adjusting the 'sitting' height of the glass to get it to seal better? Quote Link to comment Share on other sites More sharing options...
Nic Posted February 3, 2010 Share Posted February 3, 2010 (edited) I had water getting past the windscreen seal on drivers side top corner. I didn't realise water was getting in there until I started to get rust bubbling in the area the water was being trapped. It must be getting past one of the window seals, either the windscreen or side window seal. Might be worth removing the pillar pod and trim to see if you can see where it is coming through. Edited February 4, 2010 by Nic (see edit history) Quote Link to comment Share on other sites More sharing options...
Swampy442 Posted February 3, 2010 Share Posted February 3, 2010 As Nic said, windscreen seal. HAd the same prob on a Soarer and only pulling back the roof lining and pouring water over the roof revealed it. Quote Link to comment Share on other sites More sharing options...
Ewen Posted February 3, 2010 Author Share Posted February 3, 2010 Thanks guys. Quote Link to comment Share on other sites More sharing options...
SUPRALOOPY Posted February 3, 2010 Share Posted February 3, 2010 Maybe your drivings window is not set high enough to make the perfect seal when you wind the windows up, that would explain how water was getting behind you A-Pillar pod and running down the bottom. Might be worth a try adjusting the 'sitting' height of the glass to get it to seal better? Nizam?? Quote Link to comment Share on other sites More sharing options...
Matt H Posted February 4, 2010 Share Posted February 4, 2010 nizam?? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.